![]() There are a couple of steps before you start to transfer :ġ make sure your RS232 cable is configured properlyĢ the software that you use to transfer the program to the machine has all the transfer parameters set correctly ,like baud rate, stop bits etc. So if you have a smaller program that you need to repeat you can use the normal transfer mode because using BTR mode it's time consuming and requires you to restart the procedure every time you want to execute a program. I believe the standard memory size on this machines can permit you to store a program about 4000 to 6000 lines of code. It works fine, I executed programs as large as 30 000 lines with it. ![]() Old Maho machines use BTR mode option from the menu screen to transfer large programs from PC that are to big to be stored in memory, Basically the controller loads and executes a couple of program lines and in the mean time deletes the executed lines and loads others. ThanksHy there are two ways to go about DNC transfer, one is BTR and the other is the normal transfer mode. may you tell me how do you prepare your machine to run the programs in DNC mode? actually, The factory that I work with is using solidcam, and sadly, I do not have the sufficient experience in g-code to make a post.Īnother question please, we have a big problem in running the DNC of our maho (it is maho 700, but I think that the changes are minor between it and maho 600). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |